Three core functions of lithium battery BMS and five misunderstandings

The three core functions of BMS are battery cell monitoring, state of charge (SOC) estimation, and cell balancing.

Kernfunktionen von BMS

1) Zellüberwachungstechnologie

1. Single battery voltage collection; 2. Single battery temperature collection; 3. Battery pack current detection;

The accurate measurement of temperature is also very important for the working status of the battery pack, including the temperature measurement of a single battery and the temperature monitoring of the cooling liquid of the battery pack. This requires a reasonable setting of the location and number of temperature sensors to be used in order to form a good cooperation with the BMS control module. The monitoring of the temperature of the cooling liquid of the battery pack focuses on the temperature of the fluid at the inlet and the outlet, and the selection of monitoring accuracy is similar to that of a single battery.

2) SOC-Technologie (State of Charge): Einfach ausgedrückt, wie viel Leistung ist noch in der Batterie vorhanden

SOC is the most important parameter in BMS. Because everything else is based on SOC, its accuracy and robustness (also called error correction capability) are extremely important. If there is no accurate SOC, no amount of protection functions can make the BMS work normally, because the battery will often be in a protected state, and it will not be able to extend the life of the battery.

The higher the accuracy of the estimation accuracy of SOC, the higher the cruising range of the electric vehicle for the battery of the same capacity. High-precision SOC estimation can maximize the efficiency of the battery pack.

3) Ausgleichstechnologie

Passive balancing generally uses resistance to release the “excess power” of high-capacity batteries to achieve the purpose of balancing. The circuit is simple and reliable, and the cost is low, but the battery efficiency is also low.

During active equalization, the excess power is transferred to high-capacity cells, and during discharging, the excess power is transferred to low-capacity cells, which can improve the use efficiency, but the cost is higher, the circuit is complex, and the reliability is low. In the future, with the improvement of battery cell consistency, the demand for passive balance may decrease.

Misunderstandings about BMS

1) Je mehr Funktionen, desto besser. Die Funktionen können den Anforderungen entsprechen, nicht je mehr, desto besser. Je einfacher das System, desto höher die Zuverlässigkeit.

2) Deliberately pursue the acquisition accuracy of parameters such as voltage or temperature. The reason is as above, the accuracy only needs to be satisfied. Excessive accuracy will not necessarily improve the performance of the BMS, but will increase the cost on the contrary.

3) BMS can repair batteries with poor performance. BMS cannot repair poorly-performing batteries, at best, it can slow down its deterioration and suppress its impact.

4) Equalization can solve the inconsistency of the battery’s own capacity. Separate charge balance or discharge balance does not significantly improve the capacity difference, and only high current discharge balance can improve the capacity inconsistency.

5) Blindly pursue consistent charging or discharging cut-off voltage. For a BMS with only charge equalization or discharge equalization, blindly pursuing the end of the cut-off voltage consistency is meaningless. It is only necessary to study the consistency of the terminal cut-off voltage when the high-current charge and discharge balance is also available.